Placing The Powerflor
Once the Powerflor arrives at the site, the panels are stagged by stacking the floor panels across the area of the installation. Once this is complete, a foam underlay is rolled out onto the floor to prevent the panels from shifting. Floor panels are then placed tightly next to each other starting from the corner of the install area. Full panels are placed into the area leaving open area only where full panels will not fit. Leaving these areas for edge panels and cut panels. Once the room is filled, edge panels are cut to fit the remainder of the room and pre-glued carpet panels are palced on these cut panels.
Powerflor Install Images:
Placement of the Floor
Outlet Panel Install
Edge Cuts
Adding carpet to edges
